MX1508 DC Motor Driver Module PWM Speed Dual H-Bridge Stepper Motor (L298N mini) aff_prototyping Note: This product is NOT

Note: This product is NOT a medical device and is not intended to be used as such or as an accessory to such nor diagnose or treat any conditions

23sec/60degree (4

The sensor itself has a native resolution of 5 megapixel

Higher voltages could start negatively affecting the life of the motor

This single channel Relay Module operates at 5V TTL signal and is perfect for common Arduino/Raspberry Pi control applications

MX1508 DC Motor Driver Module PWM Speed Dual H-Bridge Stepper Motor (L298N mini) aff_prototyping Note: This product is NOTDetails: Dual H bridge motor driver, can drive two DC motors or a 4 wire two phase stepper motor. The module supply voltage 2V 10V. Signal input voltage 1. 8 7V. Single Operating current 1. 5A, peak current up to 2. 5A, low standby current (less than 0. 1uA). Built in common conduction circuit, when the input pin is left floating, the motor does not malfunction. Built in thermal protection circuit with hysteresis effects (TSD), without worrying about